Introduction
The biggest ambition of any young wizard is to get their own wand and go to Hogwarts. Still convinced that your owl must have lost its way? No matter! You can still have an incredible wand without traveling to Ollivander's. While it might not choose you, it makes the perfect prop for your newly purchased robes!
Task
I'am going to teach you how to make Harry Potter Wands with cheap Materials. So you can play with your Friends and Families
Process
1.Start to roll a sheet of paper into a thin, tight stick. Start at the bottom left corner of the paper and roll it towards the upper right corner. Stop when you reach past the widest point of the paper.
2.Apply some liquid glue on the last third of the paper. To avoid making the paper too soggy, apply the glue in a thin layer with a brush. At this point, you can also add a core to your wand. Here are some options:
- Phoenix feather: red, orange, or yellow feather.
- Dragon heartstring: piece of red yarn.
- Unicorn hair: silver or iridescent thread or tinsel.
3.Finish rolling the paper and hold it until the glue dries. This can take 20 to 30 minutes. If you do not wish to hold your wand for that long, you can secure it with some string or twist ties. The glue must be dry before you move on.
4.Trim the ends off. The tightly-rolled paper is probably very pointy at both ends. Use a pair of scissors or a craft knife to trim off both of the pointy ends. You will want to trim off one end more than the other. This will make the end wider, suitable for the base of your wand.
5.Apply some hot glue to both ends of the wand. This will seal the tube further, and prevent it from unraveling. For an extra touch, hot glue a small fancy bead or button to the bottom of your wand. Make sure that the bead or button is the same width as your wand; it shouldn't go past the edges.
6.Use hot glue to draw designs on your wand. You can use the hot glue to build up a handle for your wand; they are typically the length of your finger. You can also use the glue gun to draw swirly designs on the rest of the wand.
- If you'd like, you can hot glue fancy beads or buttons to the handle to make fancy designs.
7.Seal the wand with some primer. You want using paint primer, gesso, or even decoupage glue (such as Mod Podge). Allow the primer to dry before continuing. This will prevent the paper from becoming too soggy while you paint it. If it becomes soggy, it can fall apart.
8.Paint the wand a base color using acrylic paint. Most wands will be some shade of brown, but there are wands in the movies that are also black or white. You can paint your wand a solid color, or different shades of the same color. For example, you could paint your wand brown, and add some lighter and darker brown streaks to it to make it look more like wood.
9.Paint the wand a base color using acrylic paint. Most wands will be some shade of brown, but there are wands in the movies that are also black or white. You can paint your wand a solid color, or different shades of the same color. For example, you could paint your wand brown, and add some lighter and darker brown streaks to it to make it look more like wood.
10.Seal the wand, if desired. This is not completely necessary, but it will help your wand last a little longer. Go to a well-ventilated area, and set the wand down on a sheet of newspaper. Spray the wand with a clear, acrylic sealer and let it dry. Turn the wand over and spray the other side as well. Repeat this step if necessary.
- You can use a matte, satin, or glossy finish.
Evaluation
-Is it Easy to Make?
-Is it Fun to Make?
-Is it hard to Follow the Instruction?
-Would you Share this with your Friends?
Conclusion
Carefully read the instruction. Don't skip one of the steps because it may be look like crap.
Credits
Google Search
WikiHow